|
|
Post by paddy on Nov 18, 2015 18:56:03 GMT
Well the carb internals are gunk free again and it still wont start. It will if I spray fuel through the carbs but it just will not suck it up the jets. I cannot understand how by not doing a thing to perfectly good carbs for ages can make them become the biggest headache ever.
|
|
|
|
Post by bluedog59 on Nov 18, 2015 19:11:55 GMT
Have you tried taking the drain screws out the float bowls to check the fuel is getting through ? If it is, maybe the fuel level is too low.
|
|
|
|
Post by paddy on Nov 18, 2015 19:17:31 GMT
Yea they're filling up. I was going to check the heights but thought ah fuck it and put the things together. They are all as per manual around 14mm, maybe I should put them all at 13mm. That'll be tomorrows job or Fridays.
|
|
|
|
Post by rusty on Nov 18, 2015 19:21:26 GMT
If fuel is getting into the bowls ok then it's obviously not being squirted into the engine properly...that would be the jets I would have thought:-/
|
|
|
|
Post by bigkenxx on Nov 18, 2015 19:21:53 GMT
Let me have a think
|
|
|
|
Post by rusty on Nov 18, 2015 19:22:36 GMT
|
|
|
|
Post by paddy on Nov 18, 2015 19:26:52 GMT
If fuel is getting into the bowls ok then it's obviously not being squirted into the engine properly...that would be the jets I would have thought:-/ But the fuel still needs to reach the jets, the jets are clear btw |
|
|
|
Post by rusty on Nov 18, 2015 19:31:45 GMT
If fuel is getting into the bowls ok then it's obviously not being squirted into the engine properly...that would be the jets I would have thought:-/ But the fuel still needs to reach the jets, the jets are clear btw I dunno then lol |
|
|
|
Post by paddy on Nov 18, 2015 19:36:26 GMT
Well hopefully ill get time tomorrow and eliminate float heights
|
|
|
|
Post by bigkenxx on Nov 18, 2015 20:02:09 GMT
Right all I can think of is that the higher the fuel level technically the less vacuum you need to draw up fuel from the jet this is hurting my head so try increase the fuel in the bowls paddy , are the plugs wet ? Did you measure the floats with the floats only resting on the float needles not depressing them?
|
|
|
|
Post by paddy on Nov 18, 2015 20:10:10 GMT
That's how I done them yes, using digi verniers
|
|
|
|
Post by bigkenxx on Nov 18, 2015 20:24:17 GMT
Are the plugs wet ? Id try raise the fuel level paddy
|
|
|
|
Post by bigkenxx on Nov 18, 2015 20:25:20 GMT
We're the floats out before ? Put them back to what they were?
|
|
|
|
Post by paddy on Nov 18, 2015 20:28:36 GMT
You mean into the same carb??? eeerrrrr pass.
|
|
|
|
Post by paddy on Nov 18, 2015 20:50:37 GMT
The only time I could have mixed them up is when I stripped them to put in the tank the first time. However I cant remember if I removed the floats but thankfully I took a pic so I will check
|
|
