|
Post by bigkenxx on Nov 21, 2015 20:20:13 GMT
viscounts were lovely
|
|
|
Post by paddy on Nov 21, 2015 20:49:49 GMT
Well I couldn't wait for a full charge so gave it a try. No1 carb was pissing out instantly. However it was trying so I need to adjust that float so I can allow the bowls to fill properly and try agsin tomorrow. Lots of suction btw even with my gay gloves on.
|
|
|
Post by bigkenxx on Nov 21, 2015 20:58:56 GMT
Oioooooo we are near now it's got to run tomorrow can't wait for the next instalment
|
|
|
Post by paddy on Nov 21, 2015 21:01:58 GMT
Oioooooo we are near now it's got to run tomorrow can't wait for the next instalment If it runs that next instalment will be a video, maybe with a victory dance throw in
|
|
|
Post by rusty on Nov 21, 2015 22:03:01 GMT
Looking forward to that video:-D
|
|
|
Post by quazi on Nov 21, 2015 22:53:32 GMT
You have to dress up in a banana suit and do this.........
|
|
|
Post by bigkenxx on Nov 22, 2015 8:44:52 GMT
Come on paddy get that battery charged and don't give up till it's running
|
|
|
Post by paddy on Nov 22, 2015 9:08:03 GMT
It's charged, gonna have some toast and have a poo then sort that leaking carb and try again
|
|
|
Post by kokolis on Nov 22, 2015 9:39:08 GMT
The vm29ss even bored out to 33mm need no pilot change, the mixture screws can easily compensate the different settings, jets, pods, open filter, because them are mechanical carbs, not cv,s
|
|
|
Post by paddy on Nov 22, 2015 10:52:08 GMT
Sorted the leaky carb, the float was stuck and very stiff and is now bobbing up and down on the float needle. Cleaned the spark plugs, just dug out the hair dryer to aid the airbox rubbers install. I'm hopefull but the way it always go it ain't gonna start. Yes negative thinking, that way I'm never disappointed but occasionally nicely surprised
|
|
|
Post by paddy on Nov 22, 2015 11:51:58 GMT
It wasn't starting still just popping out the exhaust so I put the old plugs back in and the old bitch fired up immediately. Running shyte but running.
|
|
|
Post by bluedog59 on Nov 22, 2015 11:54:56 GMT
Yeah !!!!! Did you switch it off or did it cut out after firing ?
|
|
|
Post by paddy on Nov 22, 2015 12:25:09 GMT
Cut out
|
|
|
Post by paddy on Nov 22, 2015 13:49:20 GMT
The throttle idle screw fell out and I cant get the thread to bite so I had to hold the throttle a little bit for this one.
Prior to this video I had it idling until it ran out if fuel whilst bluedog was on the phone.
|
|
|
Post by gsexr on Nov 22, 2015 13:53:02 GMT
why did it cut out ? did you get oil pressure up first ? as it sounded yeeeeeeeeerrrrrrr ?
|
|